Ingredients

Contains: Liquified Petroleum Gas, Acetone, N-Butyl Acetate, Dimethyl Carbonate Petroleum Distillates and Aromatic Hydrocarbons.

Directions

Priming: Use of a stops rust primer provides added corrosion protection, superior adhesion and hiding and is especially recommended for bare wood and metal. Painting: Shake can vigorously for one minute after mixing ball begins to rattle. If mixing balls fails to rattle, do not strike can. Contact rust-oleum. Shake often during use. Keep the can the same distance from the surface. Recommended distance from the surface will vary based on spray selection. Scan QR code for details. Spray in a steady back-and-forth motion or up-and-down motion, slightly overlapping each stroke. Spray at any angle. Keep the can in motion while spraying. Apply 2 or more light coats a few minutes apart. Turn dial to lock position when fished spraying. Dry & recoat times based on 70 degrees F (21 degrees C) - 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 2-4 hours, to handle in 5-9 hours and fully dry in 24 hours. Apply a second coat or clear coat within 1 hour or after 48 hours. Apply clear in 2-3 light coats a few minutes apart. Primers may be top coated immediately. Dial Care & Clogging: To prevent clogging, clean face of the dial with mineral spirits when finished spraying. Do not remove cap or dial.

Clean-Up: To remove wet paint, clean with mineral spirits. Throw away empty can in trash pickup. Do not burn or place in home trash compactor.

Warnings

Warning: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. , First Aid: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued difficulty is experienced, get medical attention immediately. In case of eye contact, flush immediately with plenty of water for at least 15 minutes and get medical attention; for skin, wash thoroughly with soap and water. , Danger! Extremely flammable liquid and vapor. Vapor harmful. Vapors may cause flash fire. Contents under pressure. See other cautions on back panel. Warning! If you scrape, sand or remove old paint, you may release lead dust. Lead is toxic. Contact the National Lead Information hotline at 1-800-424-LEAD or log on to www.epa.gov/fead. Vapor harmful. May effect the brain or nervous system causing dizziness, headache or nausea. Causes eye, skin, nose and throat irritation. Do not puncture, strike or incinerate (burn) container. Exposure to heat or prolonged exposure to sun may cause bursting. Do not expose to heat or store at temperatures above 120 degrees F (48 degrees C). Notice: Reports have associated repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal. Vapors may ignite explosively. Keep away from heat, sparks and flame. Do not smoke. Extinguish all flames and pilot lights and turn off stoves, heaters, electric motors and other sources of ignition during use and until all vapors are gone. Prevent build-up of vapors by opening all windows and door to achieve cross-ventilation. Use only with adequate ventilation. Do not breathe dust, vapor or spray mist. Ensure fresh air entry during application and drying. If you experience eye watering, headache or dizziness or if air monitoring demonstrates vaporimist levels are above applicable limits wear an appropriate, properly fitted respirator (NIOSH approved) during and after application. Follow respirator manufacturer's directions for respirator use. Avoid contact with eyes, skin and clothing. Keep out of reach of children. For emergency, call your physician, local poison control center or local emergency room. For product health information, call: (800) 431-4785. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal regulations.